Greys GRXI 7/8

running bear

Well-known member
Joined
Oct 23, 2009
Messages
473
Location
North County Dublin
You reverse the bearing on the spindle iirc. Probably andemo on yputube somewhere.

Simple as pulling it off and putting it back on. I have the salmon size so assume the trout is the same. If you dont have any joy doing that, i'll look when i get a min this evening.
 

running bear

Well-known member
Joined
Oct 23, 2009
Messages
473
Location
North County Dublin
I just took a quick look, there's a flange/collar/perhaps an o ring and a pin holding the bearing. Unless the pin pops, and the ring slides put it might be a case of opening screw on drag knob to reverse it.
 

baldrico1

Active member
Joined
Apr 15, 2016
Messages
31
Location
Kingdom of Fife
Maybe a bit late
1.Remove the spool out of the frame
2.Turn the spool over, remove the two fixing screws from the housing plate.
3.Rotate the housing plate a few degrees anti clockwise to locate alternate screw holes. The protruding right hand plunger will disappear beneath the housing and the left hand plunger will appear.
5.Replace fixing screws
6.Replace the spool, your reel should now be left hand wind.
 

Latest posts

Top